TECHNICAL DATA PST-03
PEEL STOP
®
TRIPLE THICK SPRAY
Form: GDH-384
Rev.: 062714
.DESCRIPTION AND USES .
Peel Stop
®
Triple Thick High Build Primer is a high
performance rubberized primer that stops peeling paint by
gluing down worn paint edges from previous paint jobs
that can lead to topcoat cracking. Peel Stop Triple Thick is
3 times thicker than regular primers so it fills and seals
cracked, weathered, and peeling areas, creating a
smoother, more uniform surface for finishing. It goes on
white, providing excellent hide. Use Peel Stop Triple Thick
on wood, stucco, masonry, metal and vinyl siding.
.PRODUCTS .
SKU Description
278491 12 ounce spray
. PAINTING CONDITIONS .
Use in a well ventilated area. Apply when temperature is
between 50-90°F (10-32°C) and humidity is below 85% to
ensure proper drying. Cover surrounding area to protect
from spray mist.
. PRODUCT APPLICATION .
SURFACE PREPARATION
Surfaces should be clean, dry, sound, and free of dust,
dirt, grime, grease, oil, wax, mildew, or any contamination
that may interfere with adhesion. Remove loose paint, dirt,
and rust. For general oil and water base stain-blocking,
use a Zinsser stain-blocking spray primer such as Zinsser
Bulls-Eye 1-2-3 spray or Zinsser Cover Stain spray. Spot
prime knots and severe stains with Zinsser B-I-N Shellac-
Base Primer-Sealer spray.
.PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Turn can upside
down and continue shaking for one minute and shake
occasionally during use. Hold can upright 12-18” from
surface and spray with short sweeping strokes, slightly
overlapping each stroke. Keep the can in motion while
spraying. Keep the can the same distance from the
surface. Apply multiple coats, as necessary, at no more
than 10 mils wet per coat. Peel Stop can be applied up to
30 mils wet. Wait 2-3 minutes between coats. Do not use
near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 30 minutes. Apply a latex or alkyd
topcoat after 2 hours. Wait 4 hours before topcoating with
two part epoxies. Peel Stop can be sanded after 4 hours.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels