Zinsser 5082 Manuel d'utilisation et d'entretien

Naviguer en ligne ou télécharger Manuel d'utilisation et d'entretien pour Kit de nettoyage du matériel Zinsser 5082. Zinsser 5082 Use and Care Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
TECHNICAL DATA WRT-07
WATERTITE
®
ETCH & CLEANER
Form: GDH-193
Rev.: 101613
1
.DESCRIPTION AND USES .
WaterTite
®
Etch & Cleaner is a sulfamic acid-based
cleaning and etching solution suitable for removing
efflorescence (white powdery salt-like deposits caused by
moisture) and excess mortar build-up on concrete, stone,
brick, tile and galvanized metal when mixed with water.
This acid solution is safer than muriatic acid. WaterTite
Etch & Cleaner provides a light etch (profile) to promote
coating penetration and adhesion over a variety of
masonry surfaces. It is suitable for cleaning and preparing
concrete ad masonry surfaces prior to patching or
application of a coating.
.FEATURES .
Fast and effective
Easily removes caked-on efflorescence
Use on interior and exterior concrete and masonry
surfaces
Safer than muriatic acid less aggressive formula
.PRODUCTS .
SKU Container Size
5082 12 ounces
.PRODUCT APPLICATION .
SURFACE PREPARATION
IMPORTANT Wear gloves, safety glasses with side
shields and avoid skin contact to prevent chemical burns.
Use a wire brush to scrape off any loose mortar or dirt.
Wash the surface with detergent to remove any oil or
grease. Allow the surface to fully dry before applying
WaterTite Etch & Cleaner.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-Approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
PRODUCT APPLICATION (cont.) .
APPLICATION
Mix 6 ounces of WaterTite Etch & Cleaner in ½ gallon of
warm water. DO NOT use a galvanized container. Water
should NOT be hot. Stir to dissolve the crystals. Apply the
solution over the entire surface and scrub with a wire
brush to remove laitance and efflorescence. Allow to
remain on the surface for 30 minutes and then rinse with
clean water. Surface should be allowed to dry completely
before applying any of the WaterTite Mold & Mildew-Proof
Waterproofing Paints or equivalent coating.
CLEAN UP
Clean tools immediately after use. Be sure the container
lid is closed and tightly sealed. Store in a cool, dry place.
KEEP OUT OF REACH OF CHILDREN.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - ETCH & CLEANER

TECHNICAL DATA WRT-07 WATERTITE® ETCH & CLEANER Form: GDH-193

Page 2 - WATERTITE ETCH & CLEANER

TECHNICAL DATA WATERTITE ETCH & CLEANER Rust-Oleum Corporation Form: GDH-193 11 Hawthorn Parkway Phone: 877•385•8155

Commentaires sur ces manuels

Pas de commentaire